Filling Machine for filling Drums on pallet

DRUM FILLING MACHINE FOR 4X200L DRUMS ON PALLET

FILLING MACHINE FOR DRUMS ON PALLET

Model No.: ADF-1200L4

Filling Material: lubricating oil/Resin/ Engine oil etc.

Filling Weight: 200kg/Drum

Filling Capacity: 200L Round Barrel (Four Drums on the same pallet)

Filling Accuracy: ±0.1% F.S. (Accuracy depends on suitable adjustment of slow feeding and the stability and consecutiveness of liquid to spray gun

Filling Speed: 40-60Barrels/hour (Depend on previous speed of feeding material, the previous speed of liquid must be 300L/MIN.)

Measure Method: Two-section Feed Control, Filling into drum on above liquid level

Drum Size: Iron Drum, Small Open Mouth

Material Connector: DN40 Rapid Flange Connector (Pressure of liquid feeding should less than 0.6MPa)

EQUIPMENT DESCRIPTION

Electric Weighing Scale with Roller Conveyor

Weighing Range: 1200kg x200g

Weighing Table Size: 1500mm X1500mm

LOVOSC LP7110 Load Cell for pieces

JB-05 Load Cell junction box

Painted Steel Platform

Roller Conveyor with no motor driven

Weighing Area Size:1500mm(L)x1500mm(W)

Material of Machine Body: Painted Steel

Material of Rollers: Galvanized steel pipe

Roller Size: Φ80mm x150mm Pitch

Conveyor has detent mechanism and switch for moving/ Stop control

Automatic Liquid Filling Machine

Φ1 1/2” FB type Two Stages pneumatic Filling Spray Gun (Material of Spray Gun is SUS 304, Sealing Material: polyvinyl fluoride), Attached Φ1 1/2” rapid connector for feeding material, which used for change material, fast disassemble.

Three-section infeed control, there is a foot valve at head of filling gun to improve filling accuracy and avoid rest of liquid overflow

Gas-collection hood used to collect flue gas, stainless steel 304 material

Offer anti-leak cup, stainless steel 304 material

Manual adjust spray gun height

Equipped with automatic promotion and demotion cylinders

Equipped with base of filling spray gun (Material: Painted stainless steel)

Included Anti-explosion pneumatic parts (pneumatic parts brand is AIRTAC)

Automatic Controller

Wall-hung type Control Box

ST510 Weighing Controller

MCGSTPC TPC7062Ti Operation Interface

FATEK FBS PLC programming control (Including RS232 modular)

Two-section liquid infeed weight control (fast-slow)

Automatic Stop and Alarm when no liquid

Roller Conveyor for empty barrels and finished barrels storing

Roller Conveyor with motor driven

Roller Size: 1500mm(L)x1500mm(W)

0.75KW gear reduction motor

Material of Machine Body: Painted Steel

Roller Material: Galvanized steel pipe

Size: Φ80mm x150mm Pitch

Machine design is based on easy assemble and disassemble, convenient for changing rollers

On weighing conveyor, installed pneumatic brake to avoid barrel move when fill in liquid to barrels

Installation Mode: On Ground

OTHER REQUIREMENT

Buyer should install the machines by themselves and seller can give them guide; quotation doesn’t include installation costs.

Buyer should prepare soft pipe and flange to connect with our machines to infeed liquid; Buyer should prepare pump to supply liquid to our machine and it should has reflux device; buyer should prepare separate power source AC380V, 3Phase/AC220V;1Phase; 50Hz; 20A and 4-6kgf/cm2 compressed air.